Control panel “Cupol-4L”

The control panel “Cupol-4L” is intended for 5 zones checking of FGA, has separate input for Touch Memory reader. The operation is performed in autonomous mode with light and sound signal emitting and simultaneous transmitting the notifications over the radiochannel to the centralized supervision console (CSC). The device provides outside objects with reserve voltage supply +12 V.

The main application is a centralized guarding or autonomous object guarding.

The control panel receives notifications by means measuring and value checking the zone resistance of FGA. As a notification source inserted in FGA zone, guard and fire sensors of electro-contact type with relay output and sensors with feeding over the cable can be used.

Types of transmitted notifications:

• user code (up to 12 users);
• zone status (zone current status, type, pass/fail etc.);
• violating zones described as zones with delay;
• “alarm” button calling;
• fire alarm on the object;
• power supply mode (main power supply, reserve accumulator discharge level, work condition of connected UPS and so on);
• antenna-feeder equipment and transmitter work condition;
• equipment unauthorized opening event;
• user information addressed to CSC dispatcher;
• current state information about the object (guard/on duty mode, violation zone events while interval guarding, excluded zones and so on).

While transmitting over the air, the special coding and information integrity checking is performed that allows to provide high interference protection and large operation radius of the system, protecting from unauthorized access to the radiochannel.

The device provides zone status checking by means of measuring its resistance value. While mounting on the object, devices are automatically calibrated under the appropriated zone resistance and terminating resistors. Total zone resistance and terminating resistor should be in range 0, 5…5 kOhm.

The control panel allows to:

• Check the status of zones;
• Make the calibration of inputs;
• Set and delete codes of user electronic keys;
• Check the antenna-feeder section.

Programming of the control panel is possible after connection with the computer under appropriate software control.

The control panel is transmitted the information over three channels: a telemetric channel, duplicating channel and alarm channel. The telemetric channel is a main guard channel. It transmits alarm notifications, events and telemetric guard information. The duplicating channel performs transmitting alarm notifications and events and does not transmit telemetric information.

Support of the following zone types:

• fast zone (transmitting the alarm notifications performs immediately after zone violating);
• zone with delay (transmitting the alarm notifications performs in specified time interval after zone violating);
• inside zone (transmitting the alarm notifications performs immediately after zone violating or in specified time interval if zones with delay were violated before);
• round-clock zone (guard round-clock zone, independent of the whole object guarding, immediate transmitting the alarm notification);
• fire zone (priority transmitting of fire alarm notification).

The equipment operates in round-clock mode, the operating temperature is +5 °C to +40 °C, the relative humidity is up to 93% (at 40 °C).